Service Manual

Workman HD Series Page 7 -- 13 Chassis

Parking Brake Caliper Service

Disassembly (Fig. 6)

1. Removecarriersidebrakepadandpadsupportfrom

caliper.

2. Remove cam side brake pad and pad support from

caliper.

3. Replace thebrakepads ifthefriction material isworn

to less than 0.135” (3.4 mm).

4. If necessary, remove lever retainer spring, pivot pins

and cam lever from caliper body.

Assembly (Fig. 6)

1. If removed, install cam lever into caliper body and

then place pivot pins into lever holes. Insert lever retain-

er spring with tangs bent away from housing until the

spring tabs contact the pivot pin at the bottom of the

housing pocket.

2. Install cam sidepad support (notch facingcam lever)

and brake pad into caliper body.

3. Slidecarriersidepadsupportandbrakepadintocali-

per body.

1. Cam lever

2. Caliper

3. Lever retainer spring

4. Pad support

5. Cam side brake pad

6. Pad support

7. Carrier side brake pad

8. Pivot pin

Figure 6

Chassis