Operator's Manual

42
4. Remove clamps securing fuel filters to fuel lines.
1
Figure 46
1. Fuel filter
5. Install new fuel filters to fuel lines with clamps
previously removed. Filters to be mounted so arrow
points toward carburetor.
Removing Debris From Engine
Cooling System
Remove debris from engine area and radiator daily, clean
more frequently in dirty conditions.
1. Turn engine off. Clean engine area thoroughly of all
debris.
2. Lift and remove radiator screen from front of radiator.
1
Figure 47
1. Radiator screen
3. Clean radiator and screen thoroughly with compressed
air.
Note: Blow debris away from radiator.
Changing Engine Coolant
1. Park machine on a level surface.
2. Raise bed (if so equipped) and place safety support on
extended lift cylinder to hold up bed.
If the engine has been running, the pressurized,
hot coolant can escape and cause burns.
• Do not open the radiator cap when the engine is
running.
• Allow engine to cool at least 15 minutes or until
the radiator cap is cool enough to touch without
burning hand.
• Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
Caution
3. Remove radiator cap.
1
Figure 48
1. Radiator cap
4. Remove reserve tank cap.