Service Manual

Workman 3000/4000 SeriesPage 6 – 26Drive Train
18.To remove shift arms:
A. Loosen and remove nut (Item 1). Remove wash-
er (Item 2) and 2nd–3rd shift arm (Item 3) together
with shift arm plate (Item 4), spring (Item 5), locknut
(Item 6), washer (Item 7) and cap screw (Item 8).
B. Loosen and remove locknut (Item 9) and washer
(Item 10) from both 1st–Rev. shift arm (Item 11) and
High–Low shift arm (not shown). Remove shift arms.
C. Loosen cap screws (Fig. 39, Item 12) and remove
keeper plates (Item 13).
D. Remove oil seals (Item 14).
E. Inspect shift arms and keeper plates for bending
or damage and replace if necessary.
19.If P.T.O. cover is on transaxle, remove cap screws
(Item 1) and nut (Item 2) with washer. Separate P.T.O.
cover (Item 3) from transaxle case. Inspect P.T.O. cover
for cracks or damage and replace if necessary.
8
5
7
6
4
3
9
10
11
1
2
Figure 38
12
13
14
Figure 39
1
3
2
Figure 40