Service Manual

Rev. D
Workman 3000/4000 SeriesPage 9 -- 10Hydraulic System
Special Tools
Order these tools from your Toro Distributor.
Hydraulic Pressure Test Kit (TOR47009)
Use to take various pressure readings for diagnostic
tests. Quick disconnect fittings provided attach directly
to mating fittings on vehicle test ports without tools. A
high pressure hose is provided for remote readings.
Contains one each: 1000 PSI (70 Bar), 5000 PSI (350
Bar) and 10000 PSI (700 Bar) gauges. Use gauges as
recommended in Testing section of this chapter.
Figure 9
Hydraulic Tester (Pressure and Flow) (TOR214678)
Use to test hydraulic circuits and components for flow
and pressure capacities as r ecommended in the Testing
sectionofthischapter. This tester includes thefollowing:
1. INLET HOSE: Hose connected from the system cir-
cuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: A simulated working loadis created in
the circuit by turning the valve to restrict flow.
3. PRESSURE GAUGE: Glycerine filled 0 to 5000 PSI
gauge to provide operating circuit pressure.
4. FLOW METER: This meter measures actual oil flow
in the operating circuit with a gauge rated from 1 to 15
GPM(5to55LPM).
5. OUTLET HOSE: A hose from the outlet side of the
hydraulic tester connects to thehydraulic system circuit.
6. FITTINGS: An assortment of hydraulic fittings are in-
cluded with this kit.
Figure 10