Installation Instructions

Vehicle Preparation continued
14. Remove lock nut and cap screw
from form lower end of each
stabilizer link. (see figure 4)
15. Remove lock nut and cap screw
securing each spring cradle along
with the stabilizer links.
16. Reverse procedures 5 though 13,
to install compression springs
provided in the kit.
17. Remove Hood and unplug
headlights.
Figure 4
Cab Installation
1. Install rear cab mounts using
fasteners retained from OEM
ROPS. Figure1
2. Install front mounts using 3/8” x1”
bolts with 3/8” flat washers outside
and 3/8” flange nut underneath.
Figure2
3. Take cab lift brackets and slide
bolt through holes in top of cab.
Figure 3
4. Lift cab off shipping pallet with
hoist. (Warning cab is heavy use
caution when maneuvering cab,
cab damage or personal injury
could occur
Figure 1
Figure 2
9