Installation Instructions

Vehicle Preparation
1. Position the vehicle on a clean level
surface, raise or remove bed, stop
engine, engage parking brake and
remove key from ignition.
2. Disconnect positive battery cable.
3. Remove ROPS and retain bolts (6). (see
Figure 1)
4. Remove (4) socket head screws that
secure each seat to vehicle. Lift both
seats from vehicle.
5. Remove knobs from control levers, then
remove center console control plate
assembly.
6. Disconnect radiator overflow tank hose at
radiator and plug hose.
7. Carefully lift seat base from vehicle.
8. Jack up front of vehicle and secure with
jack stands. (see lifting instructions in the
Workman Operators Manual)
9. Remove front wheels.
10. Remove front shock absorbers.
11. Remove screws that hold lift valve on
center console. (see figure 3)
12. Remove screws that mount center
console and move console out of the way
to have better access to suspension
springs. No need to disconnect any of
the cables. (see figure 2)
13. Install compression spring tool rod
through holes in each spring cradle, then
install nuts and washers on both ends of
each rod. Tighten one nut on each rod to
secure springs.
Note: Extended portion of each
compression spring tool must be on
opposite ends so cap screws can be
removed.
Figure 1
Preparation of Workman
Installation of compression springs
(White springs)
8
Figure 3
Figure 2
Retain:
Cylinder Support
Manual Tube
Bolts