Service Manual

Rev. A

Workman 1100/2100/2110 Drive TrainPage 5 -- 5

Adjust Ground Speed (Vehicles Without Transaxle Governor)

Note: Workman 2100 and 2110 models with serial

numbers above 240000001 are not equipped with a

transaxle governor. These models use an engine gover-

nor for speed control.

Vehicles operating at ground speeds greater than

the recommended speed will require further

distances to fully stop. Do not adjust ground

speed greater than specified.

WARNING

1. Park machine on a level surface, stop engine, set

parking brake, and remove key from the ignition switch.

Raise and latch cargo bed.

2. Lock transaxle into neutral (see Transaxle Neutral

Position in Chapter 1 -- Safety).

3. Verify engine speed to ensure correct ground speed

as follows:

A. Start engine and hold accelerator pedal to the

floor.

B. Using a tachometer, verify that engine RPM is

3300 RPM with the accelerator pedal to the floor.

C. If engine RPM is incorrect, refer to the Briggs and

Stratton Repair Manual found after Chapter 3 for

governor adjustment procedure.

4. Lower cargo bed.

1. Accelerator cable

2. Accelerator cable end

3. Governor control

Figure 5