Operator's Manual

2. Place a clean container under the fuel filter .
3. R emo v e the clamps securing the fuel filter to
the fuel lines ( Figure 37 ).
Figure 37
1. Fuel lter
4. Install the re placement filter to the fuel lines
with the clamps previously remo v ed.
Mount the filter so that the ar ro w points
to w ard the carburetor .
Electrical System
Maintenance
Replacing the Fuses
T here are 3 fuses in the electrical system. T hey are
located beneath the bed in a bo x on the right hand
side of the frame ( Figure 38 ).
Ignition System
10 amp.
Lights
10 amp.
Power Point
10 amp. (15 amp. max.)
Figure 38
1. Ignition system 3. Power point
2. Lights
Replacing the Headlights
Specification: GE Headlight #H7610
1. Set the parking brak e , tur n the ignition off , and
remo v e the k ey .
2. R eac h beneath the dash and push the headlight
out of the hood.
3. R emo v e the screws attac hing the wire har ness
to the headlight.
4. R emo v e the r ubber seal from around the
headlight ( Figure 39 ). Discard the headlight.
Figure 39
1. Rubber seal 3. Outside notch-align with
notch in hood
2. Inside notch-align with the
notch on the headlight
4. Headlight
5. Align the notc h on the inside of the seal with
the notc h on the new headlight ( Figure 39 ).
Slide the seal onto the headlight until the seal
is fir mly in place .
6. Attac h the headlight to the wire har ness using
the previously remo v ed screws .
7. Align the notc h on the outside of the seal with
the notc h in the hood. Push the headlight and
seal into the hood until it is fir mly in place .
Note: Applying soapy w ater to the outside
of the seal ma y aid in sliding the seal into the
hood.
Servicing the Battery
Warning
CALIFORNIA
Pr oposition 65 W ar ning
Batter y posts, ter minals, and r elated
accessories contain lead and lead
compounds, chemicals kno wn to the State of
Calif or nia to cause cancer and r epr oducti v e
har m. W ash hands after handling .
34