Installation Instructions

cotter pin. Position the components as shown
in Figure 6.
G001323
1
2
3
4
5
6
Figure 6
1. Actuator
4. Cotter pin
2. Lift cylinder support 5. Nylon washer
3. Clevis pi
n
6. Steel was
hers
6. Slide a nylon washer onto the actuator rod,
then slide on one steel washer.
Note: Additional steel washers are provided
and can be used to adjust the lower stop of the
actuator rod.
Step
3
Installing th
eSwitch
Parts needed for this step:
1
Switch
1Fuse,15amp
1
Clevis pin
1
Cotter pin
Procedure
1. Remove the plug from the hole in the right
side of the dash (Figure 7).
Note: If the hole in the dash is in use,
measure over 1/2 inch (13 mm) and cut
another 0.835 inch x 1.46 inch (21 mm x 35
mm) rectangular hole in the dash. Make sure
not to damage any existing components behind
the dash when cutting the hole.
G001324
1
2
3
Figure 7
1. Plugged hole
3. Cut new hole (if required)
2. Switch
2. Plug the switch into the harness connector in
the dash. Insert the switch into the hole in t he
dash (Figure 7).
3. Remove the cover to expose the fuse block.
Install a new fuse (15 amp) into the open slot
in the fuse block. Install the cove r.
4