Service Manual

Transaxle Removal and Installation

Transaxle Removal

1. Put machine on a level surface. Stop the engine and

emove key from ignition switch. Remove the bed or oth-

er attachment(s). Allow engine and radiator to cool.

2. Disconnect positive (+) and negative (–

) battery

cables from battery.

3. Remove drain plug from bottom of transaxle and allow

oil to drain into a drain pan. Install drain plug.

Figure 27

1. Drain plug

4. Note orientation of hydraulic hose and 90 fitting con-

nected to strainer on side of reservoir. Remove hydraulic

hose and 90 fitting. (NOTE: Workman 3300–D has a

steel tube line instead of a hose.)

Figure 28

1. Strainer

Drive Train

Workman 3000/4000 Series Page 6 – 17 Drive Train