Service Manual

Adjustments
Clutch Pedal Adjustment
1. Loosen jam nuts securing clutch cable to bracket on
bell housing.
NOTE: Ball joint may be removed and rotated, if addi-
tional adjustment is required.
2. Disconnect return spring from clutch lever.
3. Adjust jam nuts/or ball joint until bottom rear edge of
clutch pedal is
“A” from top of floor plate diamond pat-
tern, when an 4 lb. force is applied to pedal.
1
3
4
2
Vehicle Dimension “A”
Workman 3200 / 3100
95 + 3 mm (3.75 + .12
)
Workman 3300–D
108 + 3 mm (4.25 + .12)
Figure 9
1. Clutch cable 3. Return spring
NOTE: Force is applied so release bearing lightly con-
2. Jam nuts 4. Ball joint
tacts pressure plate fingers.
4. Verify that rear edge of clutch pedal is 140 + 3 mm
(5.5
 + .12) from top of floor plate diamond pattern. If
dimension is not attained, adjust clutch pedal up stop.
NOTE: The clutch free play should never be less than 19
mm (.75).
5. Tighten jam nuts after adjustment has been attained.
1
2
Figure 10
1. Clutch pedal 2. Clutch pedal up–stop
6. Recheck clutch safety switch adjustment. Engine
must not crank unless clutch pedal is 32 + 3 mm (1.25
+ .12) from floor
. If an adjustment is required, loosen
switch jam nuts and adjust up or down.
1
Figure 11
1. Clutch switch
Drive Train Page 6 – 6 Workman 3000/4000 Series