Operator's Manual


   
   )' 
 Loosen the locknuts and capscrews securing tail
light plates to right and left frame brackets.
 Pivot tail light plates rearward and tighten
capscrews and locknuts.
 ")+ +)'(1 /+"1&
 0",& #0"$*&1
 ")+ +)'(1 ,.2-1)-' #0"$*&1
)'20&
 Secure rear of each tail light plate to rear of frame
brackets with a 5/16-18 x 1" lg. capscrew, .344" I.D.
flatwasher and nut, as shown in figure 1.
 On left side, remove (2) capscrews, washers and
nuts securing tail light mounting bracket to tail light
plate.
 &-%&0
 &-%&0 ,.2-1)-' #0"$*&1
)'20&
 Position a fender over each tail light plate, aligning
mounting holes.
 On left side, loosely secure tail light mounting
bracket, rear of fender and tail light plate together with
(2) capscrews, washers and nuts, previously removed.
 On right side, secure rear of fender to tail light plate
with (2) 1/4-20 x 1" lg. capscrews, .281" I.D.
flatwashers and nuts
 Loosely secure front of each fender mounting
bracket to frame with a 1/4-20 x 1" lg. capscrew and
locknut.
 Loosely secure side of each fender to frame (3)
3/8-16 x 1" lg. truss head screws and locknuts.
.1& Capscrews securing fronts of fenders to
mounting brackets may have to be loosened to align all
mounting holes.
 Tighten all fasteners.
 ! )' 
 Remove and discard fasteners securing wheels.
 Mount wheels and torque nuts to 45Ć55 ftĆlb.
 !(&&+
 !(&&+ 21
)'20&
  ! )' 
 Remove jam nut from steering shaft. Slide foam
seal, steering wheel and washer onto steering shaft.
 Secure steering wheel to shaft with jam nut and
tighten it to 10-15 ftĆlb.
 Install cap to steering wheel.