Service Manual

Special Tools
Drive Shaft Yoke Flange Nut Wrench
A modified 1–1/8 box end wrench is required to remove
and install flange nut securing drive shaft yoke to stub
axle on early production machines. NOTE: If your ma-
chine has a half yoke on the stub axle, this modified tool
is not necessary.
Recommended Tool: Snap–On Part No. GOEX36B
Figure 3
Stub Axle Removal Tool
Use this tool with modified box end wrench shown above
to remove flange nut securing drive shaft yoke to stub
axle. Fabricate this tool according the dimensions
shown. Remove a rear wheel and brake drum, then at-
tach this tool to the wheel studs on the stub axle. Secure
tool with wheel nuts.
NOTE: Stub Axle shown on next page can also be used
as a removal tool if the nut is welded to the shaft.
Figure 4
Figure 5
Drive Train Page 6
– 4
Rev. A
Workman 3000/4000 Series