Service Manual

Assembly of Alternator
1. Reverse steps 1 - 8 under Disassembly and Inspec-
tion and also following the following instructions:
2. The rear bearing has an eccentric groove. Install the
sna
p ring so its projection fits in the deepest part of the
groove.
3. When installing a new rear bearing, press fit the
be
aring with its groove facing the slip ring side.
4. Heat the rear bracket when press fitting the rear
bearing into the bracket.
IMPORTANT: Put a wire through the small hole in
Figure 60
the rear bracket to lift the brushes before installing
the rotor to the rear bracket. Remove the wire after
the rotor is installed.
Liquid Cooled Diesel Engine P
age 4 - 44
Workman 3300-D/4300-D