Service Manual

Accelerator Pedal Adjustment
If engine throttle lever does not contact high idle stop
when accelerator pedal is fully depressed, an adjust-
ment to the accelerator cable is required.
1. Put vehicle into position on a level surface, stop
en
gine and engage parking brake.
NOTE: Engine must NOT be running and return spring
must
be attached.
2. Adjust ball joint on accelerator cable to allow 0.100 -
0.
250 inch clearance between accelerator pedal and top
of diamond tread floor plate, when a 25 lb. force is
applied to center of pedal. Tighten locknut.
NOTE: If you cannot get proper accelerator pedal ad-
jus
tment, put ball joint in another hole in engine throttle
lever.
IMPORTANT: Maximum high idle speed is 3650
RP
M. Do not move high idle stop bolt to get proper
accelerator pedal adjustment.
Troubleshooting
Giving Immediate attention to any indication of a prob-
lem can prevent major failures, and increase the life of
the engine.
2
3
1
Figure 13
1. Accelerator cable
2. Ball joint
3. Locknut
Never make more that one adjustment at a time, then
locate the trouble by a process of elimination. Remem-
ber the cause is usually SIMPLE, rather than mysterious
and complicated.
Liquid Cooled
Diesel Engine
Workman 3300-D/4300-D Page 4 - 15 Liquid Cooled Diesel Engine