Service Manual

Distributor Service
1
2
3
4
5
6
7
10
12
11
9
8
Figure 130
1. Distributor cap 5. Signal rotor 9. Vacuum control
2. Packing 6. Lead cable 10. Breaker plate
3. Rotor 7. Pick–up assembly 11. O–ring
4. Cover 8. Lead cable 12. Housing assembly
Disassemble and assemble parts as shown in illustra-
tion above. Also use the following instructions for specif-
ic points of disassembly, inspection and reassembly.
Distributor Inspection
1. Check cap for cracks or other damage.
2. Check rotor for cracks or other damage.
3. Check cap electrode and rotor electrode for damage.
Figure 131
Lubrication
Apply a small amount of engine oil to pin of vacuum con-
trol rod. NOTE: Excess oil can get on housing inside dur-
ing operation and cause problems.
Figure 132
Liquid Cooled Gas Engine
Page 3
– 70
Workman 3000/4000 Series