Service Manual

Transaxle Service
Transaxle Disassembly
NOTE: Item numbers in figures are shown in order of
disassembly; for example, remove Item 1 first, then Item
2
, etc. Reassemble in reverse order; for example, install
Item 1 last.
1. Remove extension spring (Item 1).
2. Loosen capscrews (Item 2) and remove bell housing
assembly from transaxle.
3. Thoroughly clean outside surface of transaxle.
Figure 37
4. Loosen capscrews (Item 1) and remove fork shaft
case (Item 2) from center plate. Note location of longer
capscrew
. Be careful when removing cover as steel
balls inside are spring loaded.
1
2
2
1
Figure 38
5. Hold your hand over the area and shift R–1 and 2
–3
levers to move rails outward so balls (Item 3), springs
(Item 2) and spindle (Item 1) can be removed.
6. Inspect fork shaft case for cracks or damage and re-
place if necessary
.
1
3
2
Figure 39
Drive Train Page 6
– 22 Workmand 3000 /4000 Series