Service Manual

Specifications
Item Specification
Front wheel toe–in 0 to 0.125 in. (0 – 3 mm)
Front tire pressure
20 x 10
 – 10, 4 ply (Std. on all turf models) 20 PSI (138 kPa) max.
175/80 D13 (Std on industrial models) 35 PSI (241 kPa) max.
Rear tire pressure
23 x 10.5
 – 12, 6 ply (Std. on Workman 3100) 32 PSI (220 kPa) max.
24 x 13
 – 12, 6 ply (Std. on all other turf models) 18 PSI (124 kPa) max.
205/75 D14 (Std. on industrial models) 50 PSI (345 kPa) max.
Wheel nut torque 45 to 55 ft–
lb (61 – 75 Nm)
Brake fluid (Fig. 1) DOT 3
IMPORTANT:On 4WD vehicles, used only Toro ap-
proved tires (see Operator’s Manual) to prevent the
clutch from locking up.
Tire Pressure
1. Air pressure needed is determined by the payload
carried.
2. The lower the air pressure, the less the compaction,
and tire marks are minimized. Lower pressure should
not be used for heavy payloads at high speeds. T
ire
damage may result.
3. High pressure should be used for heavier payloads at
higher speeds. Do not exceed the maximum pressure.
Use the following charts to determine correct tire pres-
sures for tire size and payload of turf vehicle (charts do
not apply to industrial models).
Steering, Brakes and Suspension Page 7 – 2
Rev. D
Workman 3000 Series