Service Manual

IMPORTANT:On early versions of the center plate,
use one thick, tabbed shim (Item 2) (Fig. 111).
22. Insert shim (Item 2) against the bearing. Use thick-
e
st shim possible that will permit installation of the snap
ring. (Fig. 111 and 113).
2
Figure 111
IMPORTANT:On newer versions of the center plate,
use one tabbed shim (Item 4) with three tabless
shims (Item 2) (Fig. 1
12).
Note: T
he thickest shim of the shim set (Item 2) should
be positioned against the snap ring (Fig. 112).
23. Insert tabbed shim (Item 4) against the bearing. In-
sert shim set (Item 2) against the
tabbed shim. Use
thickest shims in set possible, that will permit installation
of the snap ring. (Fig. 112 and 113).
1
3
2
Figure 112
1
5
3
6
4
2
Figure 113
1. Countershaft
4. Snap ring
2. Bearing
5.
Center plate
3. Shims 6.
Sealing cap
24. Install snap ring into the groove of the bearing hous-
ing (Fig. 113 and 114).
Figure 114
Drive Train Page 6
– 48
Rev. D
Workmand 3000 /4000 Series
4