Operator's Manual
Table Of Contents
- NO TITLE
- NO TITLE
- 1 Mounting the Seat
- 2 Activating and Charging the Battery
- 3 Installing the Battery
- 4 Installing the ROPS (Rollover Protection Structure)
- 5 Checking the Tire Pressure
- 6 Mounting the Front Carrier Frames
- 7 Adjusting the Carrier Frame Rollers
- 8 Installing the Oil Cooler (optional)
- 9 Installing the Cutting Units
- 10 Adjusting the Transport Height
- 11 Adding Rear Ballast
- 12 Installing the EU Decal
- NO TITLE
- NO TITLE
- Think Safety First
- Checking the Engine Oil
- Filling the Fuel Tank
- Checking the Cooling System
- Checking the Hydraulic Fluid Level
- Draining Water from the Fuel Filter
- Checking the Tire Pressure
- Checking the Torque of the Wheel Nuts
- Checking the Reel-to-Bedknife Contact
- Break-in Period
- Starting and Stopping the Machine
- Checking the Safety Interlock System
- Setting the Reel Speed
- Preparing the Machine for Mowing
- Training Period
- Before Mowing
- Mowing Procedures
- Transport Operation
- Inspection and Cleanup After Mowing
- Towing the Machine
- Daily Maintenance Checklist
- Servicing the Air Cleaner
- Changing the Engine Oil and Filter
- Servicing the Fuel Filter
- Inspecting the Fuel Lines and Connections
- Servicing the Battery
- Storing the Battery
- Locating the Fuses
- Adjusting the Transmission for Neutral
- Adjusting the Transport Speed
- Adjusting the Mowing Speed
- Cleaning the Radiator Screen
- Adjusting the Brakes
- Adjusting the Alternator Belt
- Adjusting the Cutting Unit Lift/Drop
- Backlapping the Reels
- Changing the Hydraulic Oil and Filter
- Checking the Hydraulic Lines and Hoses
- NO TITLE
Lubrication
Themachinehasgreasettingsthatmustbelubricated
regularlywithNo.2general-purpose,lithium-basegrease.If
themachineisoperatedundernormalconditions,lubricate
allbearingsandbushingsafterevery50hoursofoperation.
Lubricatettingsimmediatelyaftereverywashing,regardless
oftheintervallisted.
Thefollowingmachinebearingsandbushingsmustbe
lubricated:
•Rearwheelhub(1)(Figure33)
•Castorbearing(1)(Figure33)
•Steeringcylinder(2)(
Figure33)
•Liftarms(3)(Figure34)
•Tractionpedalpivot(1)(Figure35)
•Carrierframepivot(3)(Figure36)
Figure33
Figure34
Figure35
G016483
Figure36
1.Wipethegreasettingcleansoforeignmattercannot
beforcedintothebearingorbushing.
2.Pumpgreaseintothebearingorbushing.
3.Wipeupexcessgrease.
4.Applygreasetothereelmotorsplineshaftandontothe
liftarmwhenthecuttingunitisremovedforservice.
5.ApplyafewdropsofSAE30engineoilorspray
lubricant(WD40)dailytoallpivotpointsafter
cleaning.
Note:RefertotheCuttingUnitOperator’sManualforcutting
unitlubricationrequirements.
34