Service Manual

Greensmaster 3200/3200–DPage 8 – 38Cutting Units
Lubrication
Single Point Adjust cutting units have seven grease fit-
tings and 4–Bolt units have six fittings. Each grease fit-
ting must be lubricated regularly with No. 2 multipurpose
lithium base grease.
The grease fitting locations are: the bedknife pivot hub
(Single Point Adjust only, (Fig. 46)), both reel bearings,
and two on both the front and rear roller.
IMPORTANT: Lubricate cutting units immediately
after washing helps purge water out of bearings
and increases bearing life. Grease immediately af-
ter washing regardless of the service interval listed.
1. Wipe each grease fitting with a clean rag.
IMPORTANT: Do not apply too much pressure, or
the grease seals will be permanently damaged. Use
only a hand pumped grease gun.
2. Apply grease until pressure is felt against handle.
3. Wipe excess grease from the fittings.
Figure 46
SINGLE POINT ADJUST
Figure 47
4–BOLT ADJUST