Service Manual

Greensmaster 3200/3200–D
Page 7 – 7
Wheels and Brakes
Rear Wheel (3WD)
1. Castor fork
2. Hydraulic motor & hub assembly
3. Hydraulic hose
4. Hydraulic hose
5. Bearing
6. Relube flangette
7. Standard flangette
8. Bearing tab
9. Hex head screw
10. Lock nut
11. Socket head screw
12. Lock nut
13. Cable tie
14. Tube clamp
15. Cover plate
16. Hex head screw
17. Lock nut
18. Clamp bracket
19. Wide head taper screw
20. 3WD decal
21. Grease fitting
22. Set screw
23. Lug nut
24. Wheel
25. Grease fitting
Figure 4
10
17
13
12
9
8
1
4
3
19
16
18
15
14
7
5
2
6
11
22
20
21
23
24
FRONT
RIGHT
25
Removal (Fig. 4)
1. Park machine on a level surface. Make sure engine
is off. Set brake and block front wheels.
2. Jack up and secure the rear wheel off the ground.
CAUTION
Support wheel (24) and motor and hub as-
sembly (12) to prevent dropping them and
causing personal injury while removing hex
head screws (9) and socket head screws
(11).
3. Remove wheel (24) and hydraulic motor and hub
assembly (2) from the castor fork (1) as follows:
A. Remove hex head screws (9) and lock nuts (10)
securing flangettes (6 and 7) and bearing tab (8).
B. Remove both socket head screws (11) and lock
nuts (12) securing the hydraulic motor and hub as-
sembly to the castor fork (1).
C. Lower wheel and hydraulic motor and hub as-
sembly from the castor fork.
4. Loosen set screws (22) on bearing (5). Pull flan-
gettes (6 and 7) and bearing from the hydraulic motor
shaft.
5. Remove grease fitting (25) from the hydraulic motor
and hub assembly (2). Remove four lug nuts (23) and
wheel (24) from the hub drive studs.
6. If the castor fork (1) requires removal, see Rear
Wheel (2WD) Removal.
Wheels & Brakes