Operator's Manual
'&$)(")/ ./-&+
++-*2 &)
0/ $-.. *) -&$%/
""+ #* ' .+*/ #/
%"! *# ( %&)"
&$0-"
Before mowing greens with the GREENSMASTER
3200-D, The Toro Company suggests that you find a
clear area and practice starting and stopping, raising
and lowering cutting units, turning, etc. This training
period will be beneficial to the operator in gaining
confidence in the performance of the
GREENSMASTER 3200-D.
This product may exceed noise levels of 85
dB(A) at the operator position. Ear protectors are
recommended, for prolonged exposure, to reduce the
potential of permanent hearing damage.
Inspect the green for debris, remove the flag from the
cup, and determine the direction best to mow. Base the
direction to mow on the previous mowing direction.
Always mow in an alternate pattern from the previous
mowing, so that the grass blades will be less apt to lay
down and therefore be difficult to trap between the reel
blades and bed knife.
Approach the green with the Functional Control
Lever in the MOW position and throttle at FULL speed.
Start on one edge of the green so the ribbon procedure
of cutting may be used. This holds compaction to a
minimum and leaves a neat, attractive pattern on the
greens.
Actuate the raise/lower-mow lever as the front
edge of the grass baskets cross the outer edge of the
green. This procedure drops the cutting units to the turf
and starts the reels.
(&'&-&4" 3*0-."'# 1&/% /%" # / /%/
/%" * 0//&)$ 0)&/ -""' &. !"'3"! 1%") '*1"-&)$
)! -&.&)$ /%"-"#*-" 3*0 .%*0'! +- /& " /* /-3 /*
$&) /%" -",0&-"! /&(&)$ )" "..-3 /* (&)&(&4" /%"
'")0+ (*1&)$ *+"-/&*)
Overlap a minimal amount with the previous cut on
return passes. To assist in maintaining a straight line
across the green and keep the machine an equal
distance from the edge of the previous cut, establish an
imaginary sight line approximately 6 to 10 feet ahead of
the machine to the edge of the uncut portion of the
green. Some find it useful to include the outer edge of
the steering wheel as part of the sight line; i.e. keep the
steering wheel edge aligned with a point that is always
kept the same distance away from the front of the
machine.
'&$)(")/ ./-&+
++-*2 &)
0/ $-.. *) -&$%/
""+ #* ' .+*/ #/
%"! *# ( %&)"
&$0-"
As the front of the baskets cross the edge of the
green, pull back on raise/lower-mow lever. This will
stop the reels and lift the cutting units. Timing of this
procedure is important, so the mowers do not cut into
the fringe area. However, as much of the green as
possible should be cut to minimize the amount of grass
left to mow around the outer periphery.