Service Bulletin

Toro Customer Bulletin GR #17-02 Page 4 of 7
Universal Groomer Updates Greens Mowers June 15, 2018
9. Gently rock the cutting unit back and forth to ensure complete drainage.
When the oil is completely drained, place the cutting unit on a level
surface.
10. Install the drain plug.
11. Use a syringe (Part No. 137-0872) to fill the drive box with 50cc of
80–90W oil. (Figure 2)
Figure 2
1. Syringe with 50cc of 80–90W gear oil
2. Fill port
12. Install the fill plug and tighten the air-vent plug. (Figure 3)
13. Torque all plugs to 3.62 to 4.75 N-m (32 to 42 in-lb).
Figure 3
1. Air-vent 3. Drain plug
2. Fill plug
Installing the Groomer Drive Cap
Note: Only for universal groomer assemblies without a rear roller brush kit
installed
1. Apply medium-strength cylindrical bonding retaining compound (such as
Green Loctite 609
®
) around the snap ring groove and the inside
diameter surface of the cap. (Figure 4)
2. Install the cap as shown in Figure 4