Operator's Manual

Figure 44

1. Mounting capscrews 2. Cam blocks

Adjusting the Lift and Mow

Pedal Height

To gain proper spool travel in the valve bank, adjust the lift

and mow pedals to equal heights as follows:

1. Place 1, 2, and 3 spools in neutral (center of travel) and

remove the transfer rod guard from the foot panel

(Fig. 45).

Figure 45

1. Transfer rod guard

2. Loosen the jam nut securing the yoke on the front of the

long control rod. Remove the cotter pin and clevis pin.

3. Move the adjustment lever by hand to level the mow

and lift pedals and adjust the yoke on the control rod

until the hole in the yoke lines up with the adjustment

lever hole (Fig. 46).

Figure 46

1. Jam nut

2. Yoke

3. Control rod

4. Adjustment lever

Leveling the Lift and Mow

Pedals

If the lift and mow pedals are not level when they are in the

neutral position, an adjustment to the lift pivot is required.

1. Loosen the nut on the back side of the lift pivot

(Fig. 47).

Figure 47

1. Lift pivot 2. Eccentric screw

2. Rotate the eccentric screw (Fig. 47) to raise or lower the

lift pivot spring, leveling the lift pivot and pedals.

3. While holding the screw, tighten the nut locking the

adjustment.