Operator's Manual
*,#(' '!!&', .* (Fig. 18) Ć Located on
front right side of control panel. Lever has two
positions: NEUTRAL and FORWARD. Pushing lever
forward engages traction drive.
)*,(* *+' (',*(% (Optional) (Fig. 18) Ć
Located on rear of handle. Push control lever forward
to engage. Lever must be engaged before engaging
traction engagement lever or engine will stop.
*.#*$ *$ (Fig. 18) Ć Located on left front
side of control panel. Use brake to slow or stop
machine. The brake can also be used as a parking
brake. Pulling the lever back over center will set the
parking brake.
"*(,,% (',*(% (Fig. 18) Ć Located on rear right side of
control panel. Lever connects to and operates throttle
linkage to carburetor. Engine speed can be varied from
1600 RPM to 3600 RPM.
"*(,,% (',*(%
*,#(' '!!&', %.*
*.# )*$ *$
)*,(* *+' (',*(% ),#('%
#!-*
% *#. '!!&', .* (Fig. 19) Ć Located on
right front corner of machine. Lever has two positions:
ENGAGE and DISENGAGE. Pull up on lever to engage
reel or push down on lever to disengage reel.
#!-*
% *#. '!!&', %.*
"($ .* (Fig. 20) Ć Located on left front of engine.
Lever has two positions: RUN and CHOKE. Move lever
to CHOKE position when starting a cold engine. After
engine starts move lever to RUN position.
-% "-,0( %. (Fig. 20) Ć Located on left front of
engine. Valve has two positions: CLOSED and OPEN.
Move lever to closed position when storing or
transporting machine. Open valve before starting
engine.
#!-*
"($ %.*
-% +"-, ( .%.
(#% ,*,* (Fig. 21) Ć Pull recoil starter handle to
start engine.
' /#," (Fig. 21) Ć Located on rear of engine.
Move switch to ON position to start engine and Off to
stop engine.
#$ ,' (Fig. 21) Ć Mounted to rear of machine,
kickstand is used to raise rear of machine for
installation or removal of transport wheels.
#!-*
(#% +,*,*
' /#,"
#$+,'