Service Manual

GR 800/1000/1010/1600/1610/2000/2600
Page 6 − 12
Wheels and Accessories
1. Cap screw
2. Lock washer
3. Shallow rim
4. Tire
5. Hub
6. Retaining lever
7. Spring
8. Bolt
9. Bolt
10. Deep rim
11. Inner tube
12. Cap screw
13. Flange nut
14. Wheel shaft
Figure 14
12 3 4
5
6
7
8
9
10
11
12
13
14
Disassembly (Fig. 14)
1. Make sure that tire is fully deflated before disassem-
bly of wheel.
2. Remove three cap screws (1) and lock washers (2)
from the shallow rim (3) and hub (5). Remove hub from
deep rim (10).
3. Remove four cap screws (12) and flange nuts (13)
from the deep rim (10) and shallow rim (3). Remove
shallow rim from the deep rim.
4. Remove bolt (9) from the hub (5). Remove bolt (8),
spring (7), and retaining lever (6) from the hub.
5. Later production wheel assemblies include a hub
bushing (Fig. 15). Make sure that bushing is in good con-
dition.
Reassembly (Fig. 14)
1. Reinstall retaining lever (6), spring (7), and bolt (8)
to the hub (5). Reinstall bolt (9) to the hub. Tighten both
bolts
2. Reinstall shallow rim (3) into the deep rim (10). Se-
cure shallow rim to the deep rim with the four cap screws
(12) and flange nuts (13). Tighten fasteners.
3. Reinstall hub (5) into deep rim (10). Secure hub to
deep rim with three cap screws (1) and lock washers (2).
Tighten fasteners.
4. Inflate tire from 12 to 15 PSI (83 to 103 kPa).
1. Hub 2. Hub bushing
Figure 15
2
1