Service Manual

GR 800/1000/1010/1600/1610/2000/2600Page 7 − 6Cutting Unit
Bearing Replacement Tool Kit − TOR238900A
The puller is used to remove the bearings from the roll-
ers. A driving tube is used to install bearings into the roll-
er. A drill bushing is used to drill into bearing shafts
without a removal hole.
Figure 6
Diameter/Circumference Measuring Tape − TOR6023
Spring steel measuring tape for accurately measuring
the circumference and outside diameter of cutting reel
and other spherical components. Tape calibration is in
fixed inch readings (no adjustments).
Figure 7
Turf Evaluator Tool − Model 04399
Many turf discrepancies are subtle and require closer
examination. In these instances, the Turf Evaluator
grass viewing tool is helpful. It can assist turf managers
and service technicians in determining causes for poor
reel mower performance and in comparing the effective
height−of−cut of one mowed surface to another. This
tool should be used with the Toro Guide to Evaluation
Reel Mower Performance and Using the Turf Evaluator
(Toro part no. 97931SL).
Figure 8