Operator's Manual

andremovethekey.Removeallthecuttingunitsfrom
themachine.
Note:Makesurethatalltheblackplastictiestraps
havebeenremovedfromthegroomerassemblies.
3.Removethecarriageboltsandnutssecuringthe
height-of-cutbracketstothecutting-unitsideplates
(Figure3).
Figure3
1.Height-of-cutbracket2.Carriagebolt
4.Loosenthescrewssecuringtheheight-of-cutbrackets
tothefrontrollershaft.
5.Removetheheight-of-cutbracketsandthefrontroller
fromthecutting-unitsideplates(Figure3).
6.Removethe4boltssecuringtheleftsideplatetothe
cuttingunitandloosentherearrollerclampnuts;pull
thesideplateoffofthecuttingunit(Figure4).
1
G021697
2
3
Figure4
1.Sideplate3.Bed-barbolt/nut
2.Rearrollerclampnut
7.Removethe2nutsandboltssecuringthecounter
weighttothesideplate.Removethecounterweight
andboltsfromthesideplate(Figure5).
Figure5
1.Counterweight
2.Bolts
8.Removethereelfromthecuttingunittoaccessthe
insideoftherightsideplate.
9.Removethetwoboltsfromtheinsideoftherightside
plateasyoudidontheleft.
10.Installthereelintothecuttingunitandsecureitwith
theleftsideplateand4boltsremovedpreviously.
11.Looselyinstallthenewrightandleftheight-of-cut
bracketstotheexistingfrontrollerwithnew5/16x
1-1/8inchboltsand5/16inchange-headlocknuts.
Positiontheheight-of-cutbracketsasshownin
Figure
6.
Note:Theleftheight-of-cutbracketismarkedwith
an“L”andtherightheight-of-cutbracketismarked
withan“R”.
G021698
Figure6
1.Height-of-cutbracket3.Carriagebolt
2.Boltandlocknut
12.Usingtheuppersquareholeineachsideplate,loosely
mounttheheight-of-cutbracketstothecutting-unit
sideplateswiththecarriageboltspreviouslyremoved
and(2)new3/8inchangenuts,positioningthemas
shownin
Figure6.
5