Service Manual

Rev. E
Reelmaster 6500-D/6700-DPage 7 - 20Cutting Units
Reel and Reel Bearings
1
2
3
4
4
6
3
5
8
7
12
11
9
10
18
15
16
14
15
17
17
19
Use tool TOR4064
Pack bearings with No. 2
general purpose grease
Apply anti--seize
lubricant to i nternal
Use tool TOR4074
to install threaded spline insert.
Apply Locite 242 to threads
Tighten to 75 -- 85 ft--lb (10.4 -- 11.8 KgM)
1. Screw
2. Bearing Housing - RH
3. Bearing
4. Grease Seal
5. Threaded Insert
6. Reel Assembly
7. Bearing Housing - LH
8. O-ring
9. Roll Pin
10. Bearing Adjustment Nut
11. End Weight
12. Screw
13. Cap Plug
14. Screw
15. Grease Fitting
16. Locknut
17. Bearing Ring
18. Plug
19. Set Screw - Hex. Socket Hd.
20. Grease Seal
21. Set Screw - Square Hd.
22. Bearing Housing - LH
23. Pressure Relief Fitting
Figure 31
Cutting Unit
Serial No. 220000001 & Up
3
10
23
15
22
21
20
splines
Apply grease to
OD of seal and
bearing
Apply grease to
OD of seal and
bearing
Apply grease to
OD of seal and
bearing