Service Manual

Reelmaster 6500-D/6700-D
Page 5 - 12
Electrical System (Rev. C)
Leak Detector Troubleshooting Guide
The following is a quick guide to the most common problems likely to be encountered. The hand-held Diagnostic
ACE is helpful for identifying specific problems
4-Beep Faults are Occurring
Oil level is incorrect
Check oil level on a level surface
Machine started on a slope (oil level error) Try again on a level surface, add oil as required
Solenoid valve unplugged Reconnect
Hydraulic tank cap is loose Tighten
Reelmaster Electronic Controller has wrong program-
ming installed
Contact an Authorized Toro Distributor
False-Alarms (continuous beeps but no leak) are Occurring
Hydraulic tank cap is loose
Tighten
Operator is making severe left turns Slow down while turning
Operator jiggles traction while waiting Leave pedal in Neutral while waiting
Solenoid valve not sealing Check if loose; replace if defective
Reelmaster Electronic Controller has wrong program-
ming installed
Contact an Authorized Toro Distributor
No Beep Occurs at Start-Up
Alarm wires are reversed or disconnected
Connect red to “+”, black to “-”
TurfDefender 4-pin connector is unplugged Reconnect
TurfDefender fuse is blown Replace
Oil Comes Out Vent
Excessive air bubbles in oil have c aused float to ele-
vate
Purge air by depressing float to bottom with a w ire in-
serted through the vent hole
Correct oil aeration