Service Manual

Reelmaster 6500–D/6700–DPage 8.1 – 20Cutting Units Rev. C

Model 03857, S/N 80302 & Up

Model 03858, S/N 81419 & Up

Model 03859, S/N 81993 & Up

Lifted Height of Outer Front Cutting Units (Enable Position)

The turnaround height of the front outer cutting units (#4

& #5) may be increased to provide additional ground

clearance on contoured fairways. Contact your distribu-

tor for assistance.

Travel of Front Three Cutting Units

Additional downward travel of the front three cutting

units may be desirable in highly contoured locations. If

any of the front three cutting units lift off the ground when

cresting a “hill”, the front carrier frame may be lowered

by removing mounting bolts and repositioning frame in

the bottom set of holes in the main frame (Fig. 36). Con-

tact your distributor for assistance.

Note: Moving the carrier frame down will decrease the

amount of clearance between the cutting units and the

ground in turnaround and transport positions and may

require adjusting the lift chain length on the cutting unit.

Figure 36

1. Carrier frame mounting bolts