Service Manual

Reelmaster 6500–D/6700–DPage 8 – 2Cutting Units Rev. B
Model 03857, S/N 80001–80301
Model 03858, S/N 80001–81418
Model 03859, S/N 80001–81992
Specifications
Figure 1
REEL CONSTRUCTION: Fairway reels. All welded. 5,
7 or 11 blades.
HEIGHT OF CUT RANGE:
5 Blade – 3/4” to 1–1/2”
7 Blade – 1/2” to 1–1/8”
11 Blade – 3/8” to 3/4”
Note: Use bedknife Part No. 93–9774 for height–of–
cuts below 1/2”.
REEL DIAMETER: 7 in.
POWER: Reel motors feature quick disconnect for re-
moval or installation onto cutting unit. Cutting units can
be driven from either end.
HEIGHT–OF–CUT & ROLLER ADJUSTMENT:
Height–of–cut adjustment is made at the rear roller with
quick locating pin and/or threaded micro–adjustment.
Front roller position is adjustable to set cutting unit atti-
tude.
BEDKNIFE AND BEDBAR ADJUSTMENT: Single
point adjustment mechanism.
CLIP FREQUENCY: .375” – 1.25”. Reel speed auto-
matically adjusts to maintain proper clip. Reel speed is
continuously calculated based on the current forward
speed, reel type (number of blades) and height of cut.
ROLLERS:
Front rollers: 3” diameter Wiehle rollers. Optional 3’’ di-
ameter full rollers, Part No. 93–3040, are available for
the front position.
Rear rollers: 2.5” diameter full rollers. All rollers use the
same heavy duty ball bearings with two conventional
single lip seals and a Toro labyrinth seal to provide four
sealing surfaces to protect the bearings.
ROLLER SCRAPER KITS:
Front Roller Scraper Part No. 95–7729
Rear Roller Scraper Kit Part No. 98–7996
(1 per kit)