Operator's Manual
&$/,#
/#' &'.#, .#, #+,.*,
,&) !,#1
,&(#, '/)$#,
%)$&)$ /#' &'.#,
Replace fuel filter if fuel flow becomes restricted, after
every 400 hours of operation or annually, whichever
comes first.
Loosen bolt and unscrew bottom filter cap from
filter assembly. Remove cap, gaskets, oĆring and filter
from assembly. Note position of gaskets and oĆring
when disassembling from filter.
Install new filter, gaskets, oĆring with filter assembly
cap.
Prime fuel system, refer to Priming Fuel System.
&$
#(*0&)$ # ,&- - Remove debris from rear
screen, oil cooler and radiator daily, clean more
frequently in dirty conditions.
#0#, -+,2 1.#, *).* %*. #)$&)#
- "($# .* #)$&)# (2 *!!/,
A. Turn engine off, release hood latch and raise
hood. Clean engine area thoroughly of all debris.
Close hood.
B. Unlatch and remove rear screen (Fig. 45).
Clean screen thoroughly.
&$/,#
#, !,##)
C. Unscrew knobs and pivot oil cooler rearward.
Clean both sides of oil cooler and radiator area
thoroughly with compressed air. * )*. /-# 1.#,
Open hood and blow debris out toward back of
machine. Pivot oil cooler back into position and
tighten knobs.
&$/,#
&' **'#,
"&.*,
*.# Fan shroud may be easily unbolted from
machine to simplify cleaning.
D. Install rear screen and secure latches.
*.# Do not use water to clean engine, as
damage may occur.
&).&)&)$ **'&)$ 2-.#( - Capacity of the
system is 3.5 gal. Always protect cooling system with a
50/50 solution of water and Peugeot recommended
anti-freeze (Part No. 93-7213) or equivalent . DO
NOT USE WATER ONLY IN COOLING SYSTEM.
A. After every 100 operating hours, inspect and
tighten hose connections. Replace any
deteriorated hoses.
B. After every 2 years, drain and flush the cooling
system. Add anti-freeze (refer to Check Cooling
System).