Operator's Manual
Lubricate and install a large O-ring into bearing
housing groove on each end of cutting unit (Fig. 3 & 5).
'%1.#
#.'+% &,1/'+%
.'+%).%#
,1+0#.3#'%&0
.'+% /*))
-##" /#+/,.
-##" /#+/,. &,)"#.
.*# 01 #
,0# Before installing cutting unit motors or
counterweights with speed sensors, lubricate internal
splines of cutting unit reel shafts with grease.
Install a counter weight onto appropriate end of
each cutting unit with capscrews provided (Fig. 3).
Thoroughly grease the cutting unit reel bearings
prior to installation on the traction unit. Grease should
be evident at the inboard reel seals. Refer to Cutting
Unit Operator's Manual for greasing procedure.
Insert a thrust washer onto horizontal shaft of pivot
knuckle as shown in figure 4.
'%1.#
..'#. $.*#
'2,0 (+1!()#
'$0 .* /0##.'+% -)0#
4+!& -'+
0##.'+% -'+
Insert the horizontal shaft of the pivot knuckle into
the mounting tube of the carrier frame (Fig. 4).
Secure pivot knuckle to carrier frame with a thrust
washer, flat washer and a flange head capscrew
(Fig. 4).
Insert a thrust washer onto vertical shaft of pivot
knuckle (Fig. 4).
Insert the vertical shaft of the pivot knuckle into lift
arm pivot hub (Fig. 4). Guide the pivot knuckle in place
between the two rubber centering bumpers in the
under side of the lift arm steering plate.
Insert the lynch pin into the cross hole on the pivot
knuckle shaft (Fig. 4).
Mount the motor to the drive end of the cutting unit
and secure with two capscrews provided (Fig. 5).
On front center and left rear cutting units, plug
speed sensor wire harness connector into traction unit
wire harness connector.
On motor side of cutting unit, insert speed sensor
end of harness through cutting unit rear frame tube
and route to counterweight.
'%1.#
,0,.
.'+%
Install small O-ring onto speed sensor and insert
sensor into hole in counterweight (Fig. 3).
Secure sensor to counterweight with a sensor
holder and a M6 x 20 mm capscrew (Fig. 3).
If fixed cutting unit position is required, insert
steering pin into pivot knuckle mounting hole (Fig. 4)
Hook spring wire around bottom of steering pin
(Fig. 4).
The Controller must be programmed with the Blade
configuration (number of Blades) on the installed
cutting units in order for the ClipAce
T
feature to
operate properly. If the Blade configuration is not set,
the cutting units will not operate in the mow position.
Do not sit in the seat. Closed Seat
Switch will void this procedure!
Rotate ignition key to $$ position.