Operator's Manual

30
TURFDEFENDER RAPID TROUBLESHOOTING GUIDE
The following is a quick guide to the most common problems likely to be encountered. The hand-held diagnostic
ACE is helpful for identifying specific problems.
4-beep faults are occurring:
Oil level is incorrect Check the tank dipstick on a level surface
Machine started on a slope (oil level error) Try again on a level surface, add oil as required
TurfDefender or loopback is unplugged Reconnect the loopback
Solenoid valve is unplugged Reconnect the solenoid valve
Hydraulic tank cap is loose Tighten the cap
False alarms (continuous beeps but no leak) are occurring:
Hydraulic tank cap is loose Tighten the cap
Operator is making severe left turns Slow down while turning
Oil level is near the “ADD” mark Add oil to the “Full” mark
Operator jiggles traction while waiting Leave pedal in Neutral while waiting
Solenoid valve is not sealing Check whether it is loose; replace it if it is defective
No beep occurs at starting:
Alarm wires are reversed or disconnected Connect red to “+” and black to “–”
The TurfDefender’s 4-pin connector is unplugged Reconnect it
The TurfDefender’s fuse is blown Replace it