Operator's Manual

Figure 14

1. Seat adjusting lever

2. Seat adjusting knob

Operating Instructions

STARTING AND STOPPING

1. Sit on the seat; keep your foot off the traction pedal. Assure

the parking brake is engaged, the traction pedal is in NEU-

TRAL, the throttle is in the SLOW position and the ENABLE/

DISABLE switch is in the DISABLE position.

2. Turn the ignition switch to ON/Preheat position. An automatic

timer will control preheat for approximately 6 seconds. The

engine will not crank until preheat light goes off. After preheat,

turn the key to START position. CRANK THE ENGINE FOR

NO LONGER THAN 15 SECONDS. Release the key when

the engine starts. If additional preheat is required, turn the key

to the OFF position, then to ON/preheat position. Repeat this

process as required.

Before servicing or making adjustments to the machine,

stop the engine and remove the key from the switch.

CAUTION

The engine will not crank over until the glow plug lamp

goes out. Glow plugs must complete their cycle before

the controller will allow the engine to crank.

WARNING

①