Service Manual

3. Install the special shoulder bolt (Fig. 81, Item 1) to
center the pump in the proper location.
4. Install the other bolts and tighten the bolts
(Item 1, 2, 3) to a torque of 20 Nm (15 ft-lb).
5. Install the seal carrier plate and a new gasket (Item 4)
and tighten the bolts to a torque of 15 Nm (11 ft-lb).
6. Put a new oil seal on tool TOR 70153 D.
7. Install the seal by tapping it fully home with a mallet.
8. Apply Formetanch or Permatex No. 2 sealant as
shown (Item a).
9. Apply silicone sealant to the oil pan using the pattern
shown in Figure 81a. Wait 10 minutes before installing
the oil pan to allow partial hardening of the gasket
material.
10. Install the oil pan (Item 5).
11. Install the bolts (Item b).
NOTE: The two shorter bolts are installed into the main
bearing cap.
12. Tighten the bolts (Item b) to a torque of 20 Nm
(15 ft-lb).
13. Wait a minimum of 1 hour for the oil pan gasket to
harden before filling with oil.
Figure 81
Figure 81a
Flywheel Installation
1. Install the flywheel. Put Locket thread lock on the
flywheel mounting bolts.
2. Install a TORFD86 flywheel locking tool.
3. Tighten the flywheel bolts to a torque of 50 Nm
(37 ft-lb).
4. Remove the flywheel locking tool.
TOR 70153D
Engine
Reelmaster 6500-D/6700-D Page 3 - 55 Engine