Service Manual

Reelmaster 6500–D/6700–DPage 8.1 – 16Cutting Units Rev. C
Model 03857, S/N 80302 & Up
Model 03858, S/N 81419 & Up
Model 03859, S/N 81993 & Up
Front Shield and Fins Adjustment
Adjust front shield and/or shield fin angle for desired
grass clippings dispersion.
1. Position cutting unit on a flat level surface.
2. To adjust fins (Fig. 28), unhook and move front
mounting tab to the straight ahead or angled position
slot.
3. To change front shield angle, loosen flange head
capscrew securing shield to right side plate, move shield
to desired angle and tighten screw.
Figure 28
1. Shield fin
2. Front grass shield
3. Front capscrew location
1
2
3
Rear Shield Adjustment
Under most conditions, best dispersion is attained when
rear shield is closed (front discharge).
When conditions are heavy or wet, rear shield may be
opened.
1. To open rear shield
(Fig. 29), loosen flange head
capscrew securing shield to left side plate, rotate shield
to open position and tighten capscrew.
Figure 29
1. Rear grass shield
2. Rear capscrew
1
2