Operator's Manual

GREASING BEARINGS AND

BUSHINGS (Fig. 27–35)

The machine has grease fittings that must be lubricated regu-

larly with No. 2 General Purpose Lithium Base Grease. If the

machine is operated under normal conditions, lubricate all

bearings and bushings after every 50 hours of operation or

immediately after every washing.

1. The grease fitting locations and quantities are: Cutting

unit carrier frame and pivot (2 ea.) (Fig. 27); Rear axle

tie rod (2), Steering cylinder ball joints (2), (Fig. 28);

Front lift cylinders (2), (Fig. 29); Front lift cylinder (1),

(Fig. 30); Rear lift cylinder pivot (2), (Fig. 31); Lift arm

pivot (3), (Fig. 32); Rear axle pivot (Fig. 33) Rear lift

arm pivots (2) (Fig. 34) and Brake pedal shaft (1)

(Fig. 35).

Figure 27

Figure 28

Figure 29

Figure 30

Figure 31

Figure 32