Operator's Manual

31
Maintenance Procedure Maintenance Interval & Service
✝ Initial break in at 10 hours
‡ Initial break in at 50 hours
❏ Initial break in at 200 hours
▼ If indicator shows red
Inspect engine timing belt
Drain and clean the fuel tank
Change hydraulic fluid
Change hydraulic oil filter
Change the front planetary gear lube
Pack 2-WHEEL DRIVE rear axle bearings
Change rear axle lubricant (4-WHEEL DRIVE)
Check rear wheel toe-in
Replace moving hoses
Replace safety switches
Flush the cooling system and replace fluid
▼ Service air filter
Replace the fuel filter
Inspect fuel lines and connections
‡ Check engine rpm (idle and full throttle)
Check rear axle oil level (4-wheel drive)
❏ Check front planetary gear lube
✝Torque wheel lug nuts
‡ Change engine oil and filter
Inspect cooling system hoses
✝ Check fan and alternator belt tension
Lubricate all grease fittings
Inspect air filter, dust cap and baffle
Check battery fluid level
Check battery cable connections
Every
400
hours
Every
800 hours
Every
200
hours
Every
100
hours
Every
50
hours
Minimum Recommended Maintenance Intervals
Recommendations:
Items are recommended every 1500 hours or
two years, whichever occurs first.
NOTE: Replace the timing belt if it is worn, cracked or oil soaked. A new timing belt should be installed
any time the belt is removed or loosened.
Maintenance