Operator's Manual

Figure 14

1. Seat adjusting lever

2. Seat adjusting knob

Operating Instructions

STARTING AND STOPPING

1. Sit on the seat; keep your foot off the traction pedal.

Assure the parking brake is engaged, the traction pedal is

in NEUTRAL, the throttle is in the SLOW position and

the ENABLE/ DISABLE switch is in the DISABLE posi-

tion.

2. Turn the ignition switch to ON/Preheat position. An auto-

matic timer will control preheat for approximately 6 sec-

onds. The engine will not crank until preheat light goes

off. After preheat, turn the key to START position.

CRANK THE ENGINE FOR NO LONGER THAN 15

SECONDS. Release the key when the engine starts. If

additional preheat is required, turn the key to the OFF

position, then to ON/preheat position. Repeat this process

as required.

Before servicing or making adjustments to the machine,

stop the engine and remove the key from the switch.

CAUTION

The engine will not crank over until the glow plug lamp

goes out. Glow plugs must complete their cycle before

the controller will allow the engine to crank.

WARNING

①