Service Manual

Reelmaster 5010 SeriesPage 4 - 46

Reel Drive Motor Cross- Over Relief Pressure Test (Reelmaster 5510 and 5610)

Use a tee fitting to install

pressure gauge in both inlet

and outlet lines of motor

being tested.

NOTE: Inlet is front hose.

Outlet is rear hose.

High Pressure

Low Pressure

Flow

MOW CONTROL

R11

BKLP2

MANIFOLD

Front

Hose

Rear

Hose

Rear

Hose

Rear

Hose

Front

Hose

Front

Hose

RM5510/5610 FRONT MOW CIRCUIT SHOWN

Figure 43

NOTE: One way to find a faulty reel motor is to have

another person observe the machine while mowing in

dense turf. A faulty motor will run slower, produce fewer

clippings and may cause clip marks (a choppy appear-

ance) on the turf.

IMPORTANT: DO NOT perform the Reel Drive Motor

Cross- Over Relief Pressure Test on Reelmaster

5210 and 5410 machines. The reel motors on these

machines do not have cross- over relief valves.

NOTE: Before testing the reel drive motor cross- over

relief pressure, make sure that reel motor is in good con-

dition by performing the Reel Drive Motor Efficiency Test

(see Reel Drive Motor Efficiency Test in this section).

Hydraulic System