Service Manual

AssemblingtheDriveSystem(continued)
C.Positionhousingtocuttingunitsideplateandsecuretocuttingunitwith
two(2)socketheadscrews.
D.Makesurethatgrommetgrooveiscorrectlyseatedonangeindrive
housingbore.
2.AssemblerollerbrushcomponentsusingFigure373asguidesalongwith
thefollowing:
A.Duringassembly,applyLoctite#243(orequivalent)whereindicatedand
torquefastenersasshown.
B.Applyalightcoatingofgreasetoinnerdiameterofthegrommetindrive
bearinghousingbeforeinstallingbrushplate.
C.Brushplateshouldbeinstalledsothatidlerpulleyassemblyistowardthe
bottomoftheplate.Also,theshoulderbolt(item15)shouldnotclampthe
brushplatetothedrivehousingduringassembly.
D.Wheninstallingdrivepulley(item17),makesurethattabsonpulley
engageslotindriveshaft.
E.Idlerarm(item7)shouldbefreetorotateafterassemblytobrushplate.
Makesurethatidlerspringisinstalledsothatitcanrotatetheidlerarm
andpulleyandapplytensiontothedrivebelt.
F.Afterdrivebeltinstallation,makesurethattheribsonthebeltareproperly
seatedinthegroovesofboththedriveanddrivenpulleysandthatthe
beltisinthecenteroftheidlerpulley.
g214810
Figure376
1.Drivenpulley3.Pulleyalignmenttool
2.Drivepulley
3.Afterassembly(includingdrivebeltinstallation),checkalignmentofpulleys
withastraightedgeplacedalongtheouterfaceofthedrivepulley.
A.Theouterfacesofthedriveanddrivenpulleys(nottheidlerpulley)
shouldbein-linewithin0.030”(0.76mm).
Reelmaster
®
5410/5510/5610Series
Page9–67
CuttingUnit:ServiceandRepairs
15216SLRevD