Service Manual

Reelmaster 5010 Series Universal Groomer (Optional)Page 9 − 7
4. If installed, remove the rear roller brush drive shield
from the gear box.
IMPORTANT: Groomer gear boxes installed on the
left side of the cutting unit use a left hand thread.
Turn the input shaft (rear roller brush drive shaft)
clockwise to remove the gear box. Groomer gear
boxes installed on the right side of the cutting unit
use a right hand thread. Turn the input shaft coun-
terclockwise to remove the gear box.
5. To detach the gear box from the cutting unit:
A. Turn the input shaft in the correct direction to
loosen it from the reel.
B. Remove the cotter pin and clevis pin from the
height adjustment rod at the front of the groomer
gear box. Discard cotter pin.
C. Continue to unscrew the input shaft and remove
the gear box from the cutting unit.
Universal
Groomer (Opt.)