Service Manual

Reelmaster 5010 SeriesPage 4 - 118
Oil Cooler
1. Screen assembly
2. Oil cooler bracket
3. Cap screw (4 used)
4. Foam seal (2 used)
5. Draw latch
6. Rivet (2 used)
7. Oil cooler
8. Hydraulic hose (2 used)
9. Flat washer (8 used)
10. Hose clamp (4 used)
11. Foam seal (2 used)
12. Washer (4 used)
13. Cap screw (2 used)
14. Mount plate (2 used)
15. Oil cooler clamp (16 used)
16. Clamp (2 used)
17. Flange nut (4 used)
Figure
103
FRONT
RIGHT
1
3
2
6
12
8
5
13
9
14
7
13
15
9
11
4
17
4
11
10
16
3
17
17
15
REELMASTER 5410/5510 SHOWN
NOTE: The oil cooler used on the Reelmaster 5610 is
different than the oil cooler used on other Reelmaster
5010 machines. Figure 104 illustrates the oil cooler
used on the Reelmaster 5610.
Removal ( Fig. 103)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Unlatch and open the rear screen.
3. Label all hydraulic connections for assembly pur-
poses. Thoroughly clean hydraulic connections prior to
loosening hydraulic hoses.
4. Loosen hose clamps that secure hydraulic hoses to
oil cooler fittings. Remove hoses from oil cooler. Allow
hoses to drain into a suitable container.
5. Rotate clamps that secure oil cooler to radiator
frame.
6. Pull oil cooler from machine.
7. If necessary, remove hydraulic fittings, clamps and
brackets from oil cooler using Figures 103 and 104 as
guides.
Hydraulic System