Service Manual

Reelmaster 5010 Series

Page 1 -- 4

Safety

Jacking Instructions

When changing attachments, tires or perform-

ing other service, use correct blocks, hoists

and jacks. Make sure machine is parked on a

solid, level surface such as a concrete floor.

Prior to raising machine, remove any attach-

ments that may interfere with the safe and

proper raising of the machine. Always chock

or block wheels. Use jack stands or other ap -

propriate load holding devices to support the

raised machine. If the machine is not properly

supported, the machine may move or fall,

which may result in personal injury.

CAUTION

Front End Jacking (Fig. 1)

1. Apply parking brake and chock both rear tires to pre-

vent the machine from moving.

2. Position jack securely under the frame axle tube, just

to the inside of the front wheel.

3. Jack front of machine off the ground.

4. Position jack stands under the frame as close to the

wheel as possible to support the machine.

Rear End Jacking (Fig. 2)

1. Apply parking brake and chock both front tires to pre-

vent the machine from moving.

2. Place jack securely at the center of the rear axle un-

der the axle pivot bracket. Jack rear of machine off the

ground.

3. Position jack stands under the frame to support the

machine.

Figure 1

1. Front wheel 2. Front jacking point

Figure 2

1. Axle center 2. Jack stand location

Safety and Instruction Decals

Numerous safety and instruction decals are affixed to

the traction unit and the cutting units of your Reelmaster.

If any decal becomes illegible or damaged, install a new

decal. Part numbers for decals are listed in your Part

Catalogs. Order replacement decals from your Autho-

rized Toro Distributor.