Service Manual

Reelmaster 5010 Series Page 4 - 105
14.Place front flange of the motor into a vise with soft
jaws and alternately torque the socket head screws to
the values identified in Figure 85.
15.On Reelmaster 5510 and 5610 reel motor, install
cross- over relief valves into rear flange if they were re-
moved. Torque relief valves 18 ft- lb (25 N- m).
16.Remove motor from vise.
17.Place a small amount of clean hydraulic oil in the inlet
of the motor and rotate the drive shaft away from the inlet
one r evolution. If any binding is noted, disassemble the
motor and check for assembly problems.
Hydraulic System