Service Manual

3. Oil the piston and tighten the piston ring clamp
(Fig. 78, Item 4).
4. Remove the connecting rod end caps.
5. Install the pistons in the bores, matching the markings
m
ade when removed, and aligning the crown recess
(Item a) on the oil filter side of the block.
6. Install the connecting rod end caps. Tighten the nuts
t
o a torque of 50 Nm (37 ft-lb).
NOTE: For choice of bearing shell thickness, see
Cr
ankcase in Identification and Specifications section.
Figure 78
Oil Seal Installation
1. Put a new oil seal on tool TOR 70153 C.
2. Install seal with lip toward the inside of the engine
block to keep the oil in. Fit the seal by tapping fully
home with a mallet.
3. Withdraw the tool with a twisting movement.
TOR 70153C
Figure 79
Oil Pump Installation
1. Install the key (Fig. 80, Item 6).
2. Install the pump (Item 7), drive chain and sprocket
(
Item 8) assembly.
Figure 80
Engine Page 3 - 54
Rev. C
Reelmaster 335-D/3500-D