Operator's Manual

17
L.H.
FRONT
L.H.
REAR
R.H.
FRONT
R.H.
REAR
CENTER
BASKET
BRACKET
BASKET
GUIDE
BASKET
GUIDE
BASKET
GUIDE
BASKET
GUIDE
BASKET
BRACKET
BASKET
BRACKET
BASKET
BRACKET
Figure 5
3. Remove hardware securing Turf compensation kit to
each end of carrier frame (Fig. 6 and 7) and reuse when
installing basket guides and basket brackets (Cutting
unit models 03506 and 03509 only).
4. Mount a basket guide (Fig. 6) to the appropriate side of
each cutting unit carrier frame (see Figure 7) with a
capscrew (5/16 x 1-3/4 in.), flat washer, and lock
washer or fasteners previously removed, as shown in
Figure 6.
1
2
Figure 6
1. Carrier frame 2. Basket guide
5. Install a roll pin (Fig. 7) into hole in appropriate side of
each cutting unit carrier frame (Fig. 5).
1
2
3
4
Figure 7
1. Carrier frame
2. Roll pin
3. Basket bracket
4. Basket collar
6. On the same side of carrier frame as roll pin is installed,
mount a basket bracket with a capscrew (5/16 x
1-3/4 in.), lock washer, flat washer, torsion spring,
basket collar, or fasteners previously removed, as
shown in Figure 7. Torsion springs are different for
left-hand and right-hand sides of carrier frames. There
are 2 left-hand and 3 right-hand springs. Longer leg of
spring is to be positioned forward as shown in Figure 8.
1
2
Figure 8
1. Basket bracket 2. Torsion spring
7. Align the mounting shaft of the cutting unit with the
pivot tube on the carrier frame. Insert the shaft into the
tube (Fig. 9).